Damper Service; 200 Hour Service; Flight Attendant Control Module Removal - SRAM RockShox ZEB Ultimate Flight Attendant Service Manual

D a m p e r S e r v i c e
Inspect each part for scratches. Do not scratch any sealing surfaces when
servicing your suspension. Scratches can cause leaks.
When replacing seals and o-rings, use your fingers or a pick to remove the
seal or o-ring. Spray RockShox Suspension Cleaner or isopropyl alcohol
onto each part and clean with a clean lint-free shop towel.
Apply SRAM Butter Grease to the new seals and o-rings.
2 0 0 H o u r S e r v i c e
1 The compression damper must be in the OPEN position before The compression damper must be in the OPEN position before
removing the Control Module. removing the Control Module.
Press and hold the Menu button until one LED pulses red. Press and hold the Menu button until one LED pulses red.
If necessary, press and release the ( + + ) or ( If necessary, press and release the (
red OPEN LED pulses. red OPEN LED pulses.
2 Remove the SRAM battery and install the battery block. Remove the SRAM battery and install the battery block.
Install the battery cover on the SRAM battery and set it aside. Install the battery cover on the SRAM battery and set it aside.
Optional: Insert the SRAM battery onto the battery charger. Optional : Insert the SRAM battery onto the battery charger.
NOTI CE
F l i g h t A t t e n d a n t C o n t r o l M o d u l e R e m o v a l
) or ( − − ) adjuster button until the ) adjuster button until the
SRAM Butter Grease
40

Damper Service