First Ribbon Installation - Sagem PHOTO EASY 160 User Manual

Liasse AZUR_GB.book Page 7 Jeudi, 21. avril 2005 4:09 16
F
IRST RIBBON INSTALLATION
Remark : Use manufacturer consumables only. These are specially designed to provide opti-
mum print quality (see Chapter 10).
Remark : Smart card validation is not necessary for the use of consumables supplied with the
printer (nature of supplies dependent on the model).
Switch on the printer. Wait 10 seconds for the printhead to lift, then:
1. Open the external flap located on the right-hand side of the printer.
2. Remove the protective foam.
3. Take the new ribbon out of its packaging and make sure that the film is
stretched after removing the card (A).
4. Install the ribbon in the position shown in the illustration below.
5. Insert the ribbon so that it is firmly seated in its housing. The locking catch
must be closed after insertion.
6. Close the external flap.
Warning :
Never touch the film cartridge with your fingers. Make sure the cartridge is
completely inserted into the printer. Check that the green locking lever is correctly
lowered.
Remark : In the event of any difficulty, check that there are no foreign objects in the film car-
tridge compartment.
A
6
- 7 -