First Ribbon Installation - Sagem Photo Easy 255 User Manual

F
IRST RIBBON INSTALLATION
Remark : Use DSR400 or DSR400T consumables only. These are specially designed to
provide you with optimum print rendering.
Switch on the printer. Wait 10 seconds for the printhead to lift, then:
1. Open the external flap located on the right-hand side of the printer.
2. Remove the protective foam.
3. Take the new ribbon out of its packaging and make sure that the film is
stretched after removing the card (A).
4. Install the ribbon in the position shown in the illustration below.
5. Lift the locking lever and push in the film cartridge until it touches the
back of the compartment the locking lever must be locked after
insertion.
6. Close the external flap.
A
6
- 7 -