Table of Contents
Advertisement
8
Fireplace Setup
A. Install Refractory
•
Remove smoke shield by removing five screws (starting
from one side: remove two, skip one, remove one, skip
one, remove two). See Figures 8.1 and 8.2.
Figure 8.1
Remove Smoke Shield
Front Face
Skip
Remove these screws.
Figure 8.2
Remove Smoke Shield
Majestic Biltmore Series • SB100 • 4013-303 Installers Manual • Rev H • 08/20
We recommend two installers for hearth stone and re-
fractory installation!
Smoke Shield
Skip
•
Position the bottom of the back refractory to the back of
the fireplace and center from side to side. See Figure 8.3.
Be sure to position it so the retainer notch is at the top.
Figure 8.3
Install Back Refractory
•
Fasten in place with the refractory retainer and screws
provided. See Figure 8.4.
Figure 8.4
Attach Back Refractory
REFRACTORY
RETAINER
37
Advertisement
Table of Contents
