Craftsman 24074292 Operator's Manual page 4

parts, breakage ofparts, andany other
condition thatmay affect operation.
Apart t hat i sdamaged should be
properly repaired orre-placed byan
authorized service c enter.
STAY A LERT -Watch w hat y ouare
doing. Usecommon sense. Donot
operate t hetool w hen youaretired.
Store these instructions byfolding in
half a nd sliding into theslotintheback
ofthe walt c harging rack.
FOR HOUSEHOLD USE ONLY.
SAVE THESE INSTRUCTIONS
e" = A •
ATTACHING THE SWEEPER TUBE
Before using, slide the sweeper tube
onto the main housing until the buttons
on both sides of the housing snap into
the corresponding openings in the
tube.
CONNECTING TOOL ATTACHMENT
TO THE POWER HANDLE
Be sure to follow the following safety
precautions when attaching and
detaching tools from the power handle.
Remove the battery from the handle
before attaching or detaching tools.
Never touch the control switches on
the power handle when attaching and
detaching tools.
To attach a tool:
1. Twist the lock ring on the power
handle to the unlocked position. (see
figure 1)
Figure 1
2. Insert the male end of the power
handle interface into the female socket
in the end of the tool attachment
making sure that it is firmly seated.
(see figure 2) The interface is keyed
so that it will only go together one
way. The handle and tool should go
together easily. If you experience
resistance in putting them together,
check that the keys on the handle are
properly aligned with the slots in the
tool.
Figure 2
3. Grasp the tool attachment firmly
with one hand (note, do not grasp on
a rotating part such as the auxiliary
handle), and twist the lock ring on the
power handle to the locked position
with the other hand. (see figure 3)