Advertisement
Quick Links
IMPORTANT
MANUAL
Do Not Throw
Away
Operator's
Manual
Model No.
257.796362
A
WARNING:
Read the Operator's
Manual
and
Follow
All Warnings
and Safety
Instructions.
Failure
To Do So
Can Result
in Serious
Injury.
Always
Wear Eye Protection
During
Operation
SE_/ , S/CRR FTSMR
ELECTRIC
BLOWER
DOUBLE
INSULATED
• Assembly
• Operation
• Maintenance
• Repair
Parts
Sold by Sears,
Roebuck
and Co., Chicago,
Ill. 60684
USA
534886441-1-03/16/91
© Sears, Roebuck
and Co., 1991
Advertisement
Related Manuals for Craftsman 257.796362
Summary of Contents for Craftsman 257.796362
- Page 1 IMPORTANT Operator's Manual Model No. 257.796362 WARNING: Read the Operator's Manual Follow All Warnings and Safety Instructions. Failure To Do So Can Result in Serious Injury. Sold by Sears, 534886441-1-03/16/91 MANUAL Do Not Throw Always Wear Eye Protection SE_/ , S/CRR FTSMR...
- Page 2 U,S, Paten_: & 4.402,108; DES. 26-3,547. Other U.S. and foreign imtents WARRANTY ON CRAFTSMAN or workmanship or rental purposes, this warranty BY RETURNING YOUR UNIT TO THE NEAREST and you may also have other rights which vary from state to state.
- Page 3 Replace damaged parts before using the unit. 6. Never run the unit without ment attached. When used as a blower, always in- stall a blower tube. When used as a vacuum, always install vacuum tubes and collection...
- Page 4 When used as a blower, always in- stall a blower tube to avoid injury from flying debris and/or impeller contact which can cause serious inju- ry. When used as a vacuum, always install vacuum tubes and collection bagassembly.
- Page 5 KNOW YOUR UNIT A. FNTRODUG_ION Your electric blower/vat is a high performance designed for tough jobs. Special Features include: • Top handle for one-handed • Direct Drive. • Weight- 12 lbs. • Convenient upright storage. KEY NO. WARNING: Replacement...
- Page 6 1. Insert blower tube into blower outlet. tube clockwise until it is firmly seated. 2. With a slight twisting motion, slide the concentrator nozzle firmly into the end of the blower tube. Figure I (inset). The fully assembled the one in Figure 7.
- Page 7 2. Remove the Vacuum Tubes and Collection Bag. 3. Secure the Vacuum Inlet Cover. Make sure that the Latch on the Vacuum Inlet Cover is securely fastened and the screw is reinstalled. Reinstall the blower tubes as shown in the "Blower Tube Assembly', section. /111, i llllluHl,,i...
- Page 8 Loop the extension cord though the cord retain- er and around the hook. b. Insert cord socket into recessed OPERATING TIPS-- A WARNinG Do not use the unit as a blower tubes properly attached .an.d/or impeller contact which A WAR.NING...
- Page 9 GENERAL MAINTENANCE A. MAINTAIN UNIT WITH WAB2_ING This blower is provided with Use only identical replacement cal repairs to the unit, including motor, etc., must be diagnosed Sears qualified service personnel. iean cause the double insulation become ineffeetive and result the operator.
- Page 10 iiiiiiii iiiiiiiiii i i ii IIIIIILI iiiiiiii ii i illll illl ' " '"' " iiiiiii i iiii NOTES - 10-...
- Page 11 QUICK Read follow Failure A. WARNINGS SAFETY 1. Wear eye protection. 2. Dress safely -- bootsor .safety shoesand longpants. 3. Check forworn, loose, missing, or damaged partsand repairor replace beforeusingthe unit. 4. Keep children, bystanders, and animalsa minimum of30 feet away from thework area. B.
- Page 12 Model No. 257.796362 Electric Blower How to Order Repair Parts SEARS SERVICE IS AT YOUR SERVICE Sold by Sears, 534886441-1-03/16/91 The Model Number will be found below the top handle with the Serial Number. Always mention the Model Number when requesting repair parts for your unit.