Assigning The Ip Address To The Camera - Sony IPELA SNC-RZ50N Install Manual

Assigning the IP
Address to the
Camera
To connect the camera to a network, you
need to assign a new IP address to the
camera.
Before assigning the IP address, connect the
camera to a computer or a network.
For details, see "Connecting to a Computer
or a Network" on page 20.
You can assign the IP address in two ways:
• Using the setup program stored in
the supplied CD-ROM
For details on the operations, see
"Assigning the IP Address Using the Setup
Program" on page 23.
• Using the ARP (Address Resolution
Protocol) commands
Open the command prompt on the computer
and enter the specified ARP commands.
For details on the operations, see

"Assigning the IP Address to the Camera

Using ARP Commands" in the User's Guide
stored in the supplied CD-ROM.
Note
For determining the IP address to be
assigned to the camera, consult your system
administrator.
Note for Windows XP Service Pack 2
• The Setup Program may not operate
correctly if you use a personal firewall or
antivirus software in your computer. In
that case, disable the software or assign an
IP address to the camera using another
method. See the User's Guide stored in the
supplied CD-ROM.
• If you use Windows XP Service Pack 2,
disable the Windows Firewall function.
Otherwise, the IP Setup Program will not
operate correctly.
To disable Windows Firewall, perform the
following operation.
22
GB
Assigning the IP Address to the Camera
1
Open Windows Firewall from
Control Panel.
On the category display, you can find
Windows Firewall in Security Center.
2
Select Off, and click OK.