Checking And Changing Fuses; Checking The Spark Plug; Checking The Front And Rear Lights - Sym Mio FS11W1-EU Series Owner's Manual

CHECKING AND CHANGING FUSES

Turn off ignition switch, and check fuses if they are intact. Replace the blown fuse with a new one
having the same specified amperage rating . Using a fuse of more than 10~20 amperes, a brass or iron
wire to replace a blown fuse is strictly prohibited to avoid damaging the electrical system and the circuit.
 Remove the storage box, and you'll find the fuse box near light.
 Open the fuse box cover, and pull out the fuse. Check it for damage or broken.
 Fuses must be firmly secured with wire connectors when replacing. Loose connections will result in
overhead and damage.
 Use only parts having the specified specification to replace electrical components such as light bulbs.
Using parts not having the specified specifications for replacement may cause the fuse to blow and
over-discharge the battery.
 Avoid spraying water directly on or around fuse box when washing the scooter.
 Take your scooter to your dealer for an inspection if a fuse is blown by unknown causes.

CHECKING THE SPARK PLUG

 Remove the cap of spark plug cable (remove
the spark plug using the spark plug wrench in
the tool kit.
 Check the electrode if it is dirty or fouled by
carbon deposits.
 Remove the carbon deposits on the electrode
with steel wire, and clean the spark plug with
gasoline, then, wipe dry with a rag.
 Check the electrode, and adjust its gap to
0.6~0.7 mm. (Check it with a feeler gauge)
 Hand tight the spark plug as far as it can go
and then tighten it another 1/2~3/4 turns with
a wrench.
WARNING：
The engine is very hot after running. Pay attention not to get burned.
Use only spark plugs suitable for the engine specifications of this scooter recommended by the
manufacturer. (Refer to specifications.)

CHECKING THE FRONT AND REAR LIGHTS

 Start engine and turn on the head lamp switch. Check if head lamp and rear lamp come on.
 Check the brightness and direction of front light by wall to see if it is correct.
 Check the head lamp cover if it is dirty, crack, or loosen.
Fuse connectors
21
8. Inspection and maintenance before riding
Burned fuse
0.6~0.7 mm