Table of Contents
Advertisement
Before using the self-clean function
The oven must be empty. Remove accessories, pans, guides or
left and right hand side rails. See the Cleaning and Care
chapter to release the guides or left and right hand side rails.
Clean the oven door and the side surfaces inside the oven
around the area with seals.
:
Risk of fire!!
The remains of food and grease as well as roasting juices can
catch fire. Use a damp cloth to clean the inside of the oven and
the accessories that will be cleaned inside the oven.
Cleaning of the accessories
The wire shelves or left and right hand side rails are not
suitable for self cleaning. Remove these from the oven.
For optimum cleaning of the oven interior, it is recommended
that the self-clean function is not used with the trays. However,
with the accessory support, the universal deep enamel tray or
the flat enamel oven tray can also be cleaned using the self-
clean function. Only clean one accessory at a time.
The shelf should not be cleaned using the self-clean function.
If your oven does not have this support, it can be purchased
from the Technical Assistance Service or over the Internet by
quoting part number 466546.
The accessory support is inserted to the right and left.
Use water to clean food remains, oil and roasting juices from
the accessories.
Place the universal deep tray or the flat oven tray on the
support.
:
Significant health risks!
Do not place non-stick baking tins or trays in the oven during
self-cleaning. The intense heat removes the non-stick surface
and creates toxic gases.
Setting
Once the cleaning level has been selected, set the oven.
Select the Self-cleaning
1.
knob.
Set the required cleaning level using the
2.
The display panel will show the cleaning level and the
symbol. Self-cleaning starts within a few seconds.
x
The oven door locks shortly after the function has started. The
H
symbol lights up on the display panel. Only when the
H
symbol turns off can the oven door be opened again.
Self-cleaning has ended.
The display panel will show
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
H
symbol on the display panel turns off.
Changing the cleaning level
The cleaning level cannot be changed once it has started.
Stopping the self-cleaning
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
H
symbol on the display panel turns off.
Delaying the end time
The oven allows you to programme the self-cleaning end time.
Self-cleaning can therefore be programmed at night for
example, leaving the oven free for use during the day.
Programme as described in section 1 and 2. Before starting the
self-cleaning, press the
0
end time with the
or
sensors.
@
A
The oven is set to standby. The display panel will show the
cleaning level and the
symbol. When self-cleaning starts, the
y
cleaning level and the
x
switches off.
Viewing the time settings
To view the duration of the cleaning level or the end time of the
self-cleaning press the
0
symbol lights up. The corresponding value will be shown for a
few seconds on the display panel.
After using the self-clean function
Once the inside of the oven has cooled, clean the ash remains
using a damp cloth.
q
function with the function control
@
or
A
sensors.
‹‹
:
‹‹
. The oven will stop heating.
sensor three times and delay the
symbol are shown. The
y
sensor repeatedly until the required
symbol
11
Advertisement
Table of Contents
