Table of Contents
Advertisement
Procedure
13
Determine the left and right sides of the machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
Perform the following procedure to prepare the
machine for attaching the blower and finishing kit.
1.
Park the machine on a level surface.
2.
Disengage the blade-control switch, engage
the parking brake, and move the motion-control
levers outward to the
3.
Shut off the engine and remove the key.
4.
Ensure that the machine is secure from
movement before you begin to work on it.
5.
Repair all bent or damaged areas of machine
deck and replace any missing parts.
6.
Clean the machine of any debris on the machine
deck or rear part of the machine to ease
installation.
Description
Upper tube
Screw (1/4 x 3/4 inches)
Washer (1/4 inch)
Locknut (1/4 inch)
Lower tube
-
position.
NEUTRAL
LOCK
Qty.
1
2
2
Install the discharge tubes.
2
1
2
Installing the Weight
Parts needed for this procedure:
1
Weight tray
1
Left weight-tray mount
1
Right weight-tray mount
1
Suitcase weight—16 kg (35 lb)
1
Retaining rod
2
Bolt (3/8 x 1-1/4 inches)
4
Flange nut (3/8 inch)
2
Carriage bolt (3/8 x 1 inch)
2
Self-tapping bolt (5/16 x 3/4 inch)
Procedure
CAUTION
The bagger changes the weight distribution of
the machine. Operating the machine without
the front weights may cause an unstable
condition, which could result in a loss of
control.
Ensure that the front weights are properly
installed before operating the machine with
the bagger attachment.
1.
Remove the existing bolt and nut from the left
and right side of the platform where you will
install the weight-tray mounts.
2.
Use the 2 self-tapping bolts (5/16 x 3/4 inch), 2
bolts (3/8 x 1-1/4 inches), and flange nuts (3/8
inch) to secure the left and right weight-tray
mounts to the machine
7
Use
(Figure
3).
Advertisement
Table of Contents
