Table of Contents
Advertisement
5.3.2
Overview of the installation technique
The following 3 different techniques are possible when installing a linear motor in a machine:
• Motor installation with divided secondary section track
• Motor installation by introducing the slide
• Motor installation by placing down motor components
5.3.3
Motor installation with divided secondary section track
Risk of crushing when moving the slide (step 3)
If you move the slides with the primary section on the installed secondary section, strong
pulling forces briefly occur in the direction of the secondary section track. There is a risk of
crushing!
• Make sure that your fingers do not protrude into the danger zone!
Requirements
For this type of installation the entire secondary section track must be able to be divided into
2 sections. In this case, the two sections must at least be as long as the slide.
Procedure
1. Install the slide together with the linear guide and the primary section.
2. Push the slide to one side. Start the installation with the secondary section track on the other
side. Proceed as explained in Chapter "Assembling individual motor components
(Page 69)". Align the secondary section track. Tighten the mounting screws according to
the specifications.
Naturally-Cooled 1FN3 Linear Motors
Operating Instructions, 06/2023, A5E52220465B AB
WARNING
5.3 Procedure when installing the motor
Installation
63
Advertisement
Table of Contents
