JVC GY-DS100U Detailed User Manual page 78

Using the Network
Connection via an Access Point
Internet Connection
This mode of connection enables access to the web functions of this camera
via the Internet from devices such as a smartphone, tablet terminal or PC.
* To use this function, it is necessary to get ready a wireless LAN router
compatible with UPnP (Universal Plug and Play) and an Internet
connection that allows a global IP address to be acquired.
"What is UPnP?" (A p. 74)
"What is global IP address?" (A p. 74)
Use a wireless LAN router that supports UPnP.
0
(Products that come with a Wi-Fi certification logo)
To check whether UPnP is supported, please refer to the instruction
manual of the wireless LAN router in use.
Memo :
Depending on the wireless LAN router in use and signal strength, you may
0
experience connection problems or slow connections.
When operating the zoom function using a smartphone, the response may
0
be slower compared to using the camera.
Obtaining a Dynamic DNS (DDNS) Account
o
By obtaining a dynamic DNS account, this unit may be used on the web as
usual even if the IP address changes when making an access to this unit via
the Internet.
Only the JVC Dynamic DNS service can be configured on this camera.
0
To obtain (register) an account, perform the following steps.
1
Access the following URL from a browser and register for a provisional
account.
(Operation on a PC or smartphone)
https://dd3.jvckenwood.com/user/
Set your e-mail address as the user name.
2
Check that you have received a confirmation e-mail to the address used
for the provisional registration, and access the URL stated in the e-mail.
(Operation on a computer or smartphone)
3
Check the account information (user name and URL for access (WAN)).
Write down the information needed for access.
78
Connection Adapter Settings and Camera Connection
o
1
Launch the wizard screen and tap 1.
"Preparation on the Camera" (A p. 75)
Available Adapter
.
2
Select "Connect with Access Point", followed by tapping 1.
Connect with Access Point
.
3
Select "Internet connection", followed by tapping 1.
Internet connection
.
4
Select the method of configuration and tap 1.
Configure WPS here.
WPS
.
5
Press the WPS button on the access point.
For more information, please refer to the instruction manual of the
access point.
6
Tap "WPS".
WPS Setup
Press the WPS Button
on the Access Point
then Touch the WPS Button
.
Wireless LAN
WPS