Document Pack Contents; Part List - Trane S9V2B040U3PSC Installation, Operation And Maintenance Manual

Table of Contents

A A c c c c e e s s s s o o r r i i e e s s

Document Pack Contents

Item

Qty.

Description

Condensate Drain Tube Assembly

Inlet Vent (2"- ADP01586 and 3" -

ADP01587)

(a)

Inlet Vent Gasket

Outlet Vent Assembly

Outlet Vent Gasket

Screws

Condensate Trap Grommet

Plug — Condensate/Gas

Plug — Electrical

Grommet — Condensate/Gas

Installation, Operation, and

Maintenance

Owner Guide

Limited Warranty

2" to 3" Coupling — CPL01544

3" inlet vent supplied with S9V2D120U5PS and S9V2D120D5PS only. 2" inlet vent supplied with all other models.

(a)

(b)

Supplied with S9V2D120U5PS and S9V2D120D5PS only.

Part List

•

Igniter

•

Flame Sensor

•

In-shot Burner(s)

•

Gas Valve

Installation, Operation, and Maintenance

Up ow/Horizontal and Dedicated Down ow

Gas-Fired, Direct/Non-Direct Vent, 2–Stage

Condensing Variable Speed Furnaces

U U p p f f l l o o w w , , C C o o n n v v e e r r t t i i b b l l e e t t o o

D D o o w w n n f f l l o o w w O O n n l l y y

H H o o r r i i z z o o n n t t a a l l R R i i g g h h t t o o r r

S9V2B040D3PSC

H H o o r r i i z z o o n n t t a a l l L L e e f f t t

S9V2B060D3PSC

S9V2B040U3PSC

S9V2B080D4PSC

S9V2B060U4PSC

S9V2C100D5PSC

S9V2B080U4PSC

S9V2D120D5PSC

S9V2C080U5PSC

S9V2C100U5PSC

S9V2D120U5PSC

WARNING

FIRE HAZARD!

Failure to follow this Warning could result in property damage, severe personal

injury, or death.

This Warning applies to installations with a ammable refrigeration system.

N N o o t t e e : : Graphics in this document are for

The furnace must be powered except for service. The furnace shall be installed

and connected according to installation instructions and wiring diagrams that

are provided with the evaporator coil.

CAUTION

COIL REQUIREMENT!

Failure to follow this Caution could result in property damage or personal injury. 4GXC* and

4MXC* coils installed on upflow furnaces in vertical, horizontal left, or horizontal right

orientations without a factory installed metal drain pan shield must use a MAY*FERCOLKITAA

kit. Coils installed on upflow furnaces must have drain pans that are suitable for 400° F

(205°C) or have a metal drain pan shield. Downflow furnaces do not require a metal drain pan

shield or the use of the MAY*FERCOLKITAA kit.

S S A A F F E E T T Y Y W W A A R R N N I I N N G G

Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning

equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person

could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that

are attached to the equipment.

S S 9 9 V V 2 2 - - S S V V X X 0 0 0 0 1 1 - - 1 1 B- - E E N N

September 2023

(b)

•

Inducer Assembly

•

Blower Motor

•

Blower Wheel

•

IFC (Integrated Furnace Control)