1. Manuals
  2. Brands
  3. GE Manuals
  4. Oven
  5. JKP85 Series
  6. Installation instructions manual

GE JKP85 Installation Instructions Manual

27” built in wall oven/ with microwave
Hide thumbs Also See for JKP85:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual, Technical & Service Manual
Installation
Instructions
"If you have questions, call 800-GE-CARES
www.GEAppliances.com"

Before you begin

Read these instructions carefully and completely
IMPORTANT
•
-Save these instructions for
local inspector's use.
IMPORTANT
•
-Observe all governing
codes and ordinances.
• Note to Installer- Be sure to leave these
instructions with the consumer.
• OWNER- Keep these instructions for future
reference.

Parts Included

8 flat head screws side trim
3 Pan head screws bottom trim

Tools You Will Need

1/8" Drill Bit &
Electric or
Hand Drill
Pub. No. 31-10480
4053P460
229C
Bottom Trim
Phillips
Screwdriver
27" Built In Wall Oven/ with
Microwave
JKP85
• ATTENTION INSTALLER!!
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A "plug and receptacle" is NOT
permitted on these products
• NOTE- This appliance must be properly
grounded.
Materials Needed
Strain Relief
Clamp
1
or visit our website at:
Wire Nuts
Junction
Box
36" of String

Advertisement

Table of Contents
loading

Related Manuals for GE JKP85

Summary of Contents for GE JKP85

  • Page 1: Before You Begin

    Pub. No. 31-10480 4053P460 229C 27” Built In Wall Oven/ with Microwave JKP85 • ATTENTION INSTALLER!! All electric wall ovens must be hard wired (direct wired) into an approved junction box. A “plug and receptacle” is NOT permitted on these products •...

  • Page 2: Important Safety Instructions

    Installation Instructions IMPORTANT SAFETY INSTRUCTIONS For Your Safety • Be sure your oven is installed properly by a qualified installer or service technician. • Be sure the oven is securely installed in a cabinet that is firmly attached to the house structure.

  • Page 3: Pre-Installation Checklist

    Installation Instructions Pre- Installation Checklist Remove packaging materials. Check behind hinges, and under false bottom. Remove labels on the outside of the door, plastic on trims and panel, and all tape around oven. Oven Racks EASY INSTALLATION OF YOUR NEW 30"...
  • Page 4 Installation Instructions Pre- Installation Checklist Place the oven on a table or platform even with the cutout opening. (Platform must support 275 lbs.) Remove the bottom trim from the top of the oven. It will be installed at the end of installation. The trim is wrapped separately and taped to the top of the unit.

  • Page 5: Installation Instructions

    Cutout for Built-In Oven W/Microwave Allow 7/8" for overlap of oven over side edges of cutout Allow a minimum of 20" for clearance to adjacent corners, drawers, walls, etc. when doors are open 20" If the cabinets do not have a solid bottom, then two braces or runners must be installed to support the weight of the oven.

  • Page 6: Attention Installer

    Electrical Connections ATTENTION INSTALLER!!! All electric wall ovens must be hard wired (direct wired) into an approved junction box. A plug and receptacle is NOT permitted on these products. Do not shorten the flexible conduit.The conduit strain Relief Clamp must be securely attached to the junction box and the flexible conduit must be securely attached to the clamp.
  • Page 7 Installation Instructions Electrial Connections NEW CONSTRUCTION AND FOUR-CONDUCTOR BRANCH CIRCUIT CONNECTION • When installing in a new construction, • When installing oven in a mobile home, or • When local codes do not permit grounding through neutral: a. Cut the neutral (White) lead from the crimp. Re-strip the neutral (white) lead to expose the proper length of conductor.
  • Page 8 Installation Instructions Placing the Oven in the Opening Sliding the Oven Into the Opening. a. Loop (do not tie) a 36” string around the conduit before the oven is slid into place. This will keep the conduit from falling behind the oven.
  • Page 9 Installation Instructions Preparing for the bottom Trim Installation a. With oven installed, take the bottom trim and center it on the bottom front edge of the cabinet opening. b. Using the trim as a template mark the center of each slot (three total) where the mounting holes will be...

  • Page 10: Pre-Test Check List

    Installation Instructions PRE-TEST CHECK LIST Remove all protective film if present, and any stickers. Check to be sure that all wiring is secure and not pinched or in contact with moving parts. Operation Checklist Remove all items from the inside of the oven.
  • Page 11 NOTES...
  • Page 12 Pub. No. 31-10480 4053P460 229C...

Table of Contents