General electric built-in oven use & care guide (24 pages)
Summary of Contents for GE JKP85
Page 1
27" Built In Wall Oven Installation nstruct=ons W/Microwave JKP85 "lf you have questions, call 800-GE-CARES visit our website at www.GEAppliances.com" CAUTION: Before you begin- read these • Note to Consumer- Keep these instructions instructions completely and carefully. for future reference.
Installation Instructions IMPORTANT SFETY INSTRUCTIONS Electrical For Your Safety Requirements • Be sure your oven is installed properly by a qualified installer or service technician. • Be sure the oven is securely installed in a This appliance must be supplied with the cabinet that is firmly attached to the house proper voltage and frequency, and connected structure.
Installation Instructions Pre-Installation Checklist Remove packaging materials. Remove the Oven Door Open the oven door to the stop broil position. Check inside microwave, behind hinges, and under false bottom. Remove labels on door, plastic on trims DOOR BY THE and panel, and all tape around oven. HANDLE! DO NOT LIFT THE Open oven door and remove...
Page 4
Installation Instruction Pre-Installation Checklist cont. [_" Place the Oven Platform Remove the Bottom Trim Place the oven on a table or platform Remove the bottom trim from the top of even with the cutout opening. (Platform the oven. It will be installed at the end of must support 225 Ibs.
Page 5
Installation Instructions Cutout for Built-In Oven W/Microwave JUNCTION BOX Cabinet Width 27" LOCATION CABINET Recommended 27" Cutout Location From Floor ..21 5/8" CUTOUT WIDTH Cutout Depth .23 1/2" 25" MIN. Allow 7/8" 25 1/4" MAX. for overlap of Cutout Width ..25" Min.
Installation Instructions Electrical Connections New Construction and Four- Turn off the circuit breaker or remove fuses to the oven branch circuit. Conductor Branch Circuit Connection With the oven in front of the cabinet • When installing in a new construction, opening on a table or platform, connect the flexible conduit to the •...
Page 7
Installation Instructions Electrical Connections cont Three-Conductor Branch Circuit Connection When connecting to a 3-conductor branch NOTE TO ELECTRICIAN: The 3 power leads circuit, if local codes permit: supplied with this appliance are UL recognized for connection to larger gauge household wiring. a.
Installation Instructions Placing the Oven In the Opening Sliding the Oven Into the Drilling the Pilot Holes Opening. a. Loop a 36" string around the conduit before the oven is slid into place. This will keep the NOTE: Before drilling the pilot holes, conduit from falling behind the oven.
Installation Instructions Replacing the Oven Door Make sure the hinge is in the door stop The oven door is heavy. You may need position. help lifting the door high enough Remove the toweling or paper towel slide it down onto the hinges. Do not holder from the hinge.
Installation Instruction PRE-TEST CHECK LIST Check that the bottom trim is installed Remove all protective film if present, and any stickers. properly (see page 7). checkt° be s urethat a'' w'rin° Check to be sure the mounting screws secure and not pinched or in contact are installed and flush with the side with moving parts.