GE JKP85 Installation Instructions Manual
GE JKP85 Installation Instructions Manual

GE JKP85 Installation Instructions Manual

27" built in wall oven/with microwave
Hide thumbs Also See for JKP85:

Advertisement

Installation
Instructions
27" Built In Wall Oven/with
Microwave
JKP85
"If you have questions, call 800-GE-CARES
or
visit our website
at:
www. GEAppliances.com"
Before you begin
Read these instructions carefully and completely
• IMPORTANT-Save
these instructions
for
local inspector's
use.
• IMPORTANT-Observe
all governing
codes and ordinances.
• Note to Installer-
Be sure to leave these
instructions
with the consumer.
• OWNER-
Keep these instructions
for future
reference.
• ATTENTION
INSTALLER!!
All electric wall ovens must be hard wired
(direct wired) into an approved
junction
box. A "plug
and receptacle"
is NOT
permitted
on these products
• NOTE- This appliance
must be properly
grounded.
Parts Included
8 flat head screws
side trim
3 Pan head screws
bottom
trim
f
Bottom Trim
Materials Needed
Strain Relief
Clamp
_¢_
Wire
Nu_ts
Junction
Box
36" of String
Tools You Will Need
1/8" Drill Bit &
Phillips
Electric or
Screwdriver
Hand Drill
Pub. No. 31-10480
229c4053P460
1

Advertisement

Table of Contents
loading

Summary of Contents for GE JKP85

  • Page 1 Installation 27" Built In Wall Oven/with Microwave Instructions JKP85 "If you have questions, call 800-GE-CARES visit our website www. GEAppliances.com" Before you begin • ATTENTION INSTALLER!! Read these instructions carefully and completely All electric wall ovens must be hard wired •...
  • Page 2: Important Safety Instructions

    Installation Instructions IMPORTANT SAFETY INSTRUCTIONS Electrical For Your Safety Requirements This appliance must be supplied with the • Be sure your oven is installed properly proper voltage and frequency, and connected a qualified installer or service technician. to an individual properly grounded branch •...
  • Page 3: Pre-Installation

    Installation Instructions Pre-Installation Checklist Remove packaging materials. Door Removal is not a requirement Check behind hinges, and under installation of the product, but is an added false bottom. Remove labels on the convenience. outside of the door, plastic on trims and panel, and all tape around oven.
  • Page 4 Installation Instructions Remove the bottom trim from the Place the oven on a table or platform Iq_" top of the oven. It will be installed even with the cutout opening. the end of installation. The trim is (Platform must support 275 Ibs.) wrapped separately and taped to the...
  • Page 5: Installation Instructions

    Installation Instructions Cutout for Built-In Oven W/Microwave JUNCTION BOX Cabinet Width 27" LOCATION CABINET Recommended 27" Cutout Location From Floor ..21 5/8" CUTOUT WIDTH Cutout Depth .23 1/2" 25" MIN. Allow 7/8" 25 1/4" MAX. for overlap of Cutout Width ..25" Min.
  • Page 6: Electrical Connections

    Installation Instructions Electrical Connections Turn off the circuit breaker or remove fuses ATTENTION INSTALLER!!! to the oven branch circuit. All electric wall ovens must be hard wired With the oven in front of the cabinet (direct wired) into an approved junction box.
  • Page 7 Installation Instructions Electrial Connections cont. NEW CONSTRUCTION FOUR-CONDUCTOR BRANCH Three-Conductor Branch CIRCUIT CONNECTION Circuit Connection • When installing in a new construction, • When installing oven in a mobile When connecting to a 3-conductor branch home, or circuit, if local codes permit: •...
  • Page 8 Installation Instructions Placing the Oven in the Opening Drilling the Pilot Holes IC-_ Sliding the Oven Into the Opening. a. Loop (do not tie) a 36" string around the Note: Before drilling the pilot holes conduit before the oven is slid into place. make sure the oven is pushed as far This will keep the conduit from falling behind back into the opening...
  • Page 9: Replacing The Oven Door

    Installation Instructions Replacing the Oven Preparing for the bottom Door Trim Installation a. With oven installed, take the bottom trim and center it on the bottom front edge of The oven door is heavy. You may need the cabinet opening. help lifting the door high enough slide it into the hinges slots.
  • Page 10: Pre-Test Check List

    Installation Instructions PRE-TEST CHECK LIST Check that the bottom trim is installed Remove all protective film if present, and any stickers. properly (see page 9). Chec to sure that all wi in0 Check to be sure the mounting screws are installed and flush with the side secure and not pinched or in contact with moving parts.
  • Page 11 NOTES...
  • Page 12 Pub. No. 31-10480 229c4053P460...

Table of Contents