Maintenance - Makita AN902 Instruction Manual

1
► 1. Trigger
1. To drive a nail, you may place the contact element
against the workpiece and pull the trigger.
2. Pull the trigger first and then place the contact
element against the workpiece.
No. 1 method is for intermittent nailing, when you wish
to drive a nail carefully and very accurately. No. 2
method is for continuous nailing.
CAUTION:
• Operating the tool without nails shortens the life
of the tool and should be avoided.
For sequential mode (intermittent
nailing mode)
1
2
► 1. Trigger 2. Change lever
Rotate the lever to the
button on the other side of the lever.
To drive a nail, you may place the contact element
against the workpiece and pull the trigger.
position while pressing the
CAUTION:
• WITH THE TRIGGER HELD IN A HALF-
PULLED POSITION, an unexpected nailing
could occur, if contact element is allowed to
re-contact against the workpiece or the other
surface under the influence of recoil.
In order to avoid this unexpected nailing, per-
form as follows;
— A. Do not place the contact element against the
workpiece with excessive force.
— B. Pull the trigger fully and hold it on for 1-2
seconds after nailing.
• Operating the tool without nails shortens the life
of the tool and should be avoided.
Jammed nailer
► 1. Hammer 2. Small rod
CAUTION:
• Always disconnect the air hose and remove the
nails from the magazine before cleaning a jam.
When the nailer becomes jammed, do as follows:
Open the magazine cap and remove the nail coil. Insert
a small rod or the like into the ejection port and tap it
with a hammer to drive out the nail jamming from the
ejection port. Reset the nail coil and close the magazine
cap.
Nails
Handle nail coils and their box carefully. If the nail coils
have been handled roughly, they may be out of shape
or their connector breaks, causing poor nail feed.
Avoid storing nails in a very humid or hot place or place
exposed to direct sunlight.

MAINTENANCE

CAUTION:
• Always disconnect the air hose from the tool
before attempting to perform inspection or
maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
7 ENGLISH
1
2