Operation - Husky HOTC8010BB1S Use And Care Manual

Operation

1
Locking and unlocking the unit
IMPORTANT : The drawers must be fully closed before
locking / unlocking the unit.
□
To lock the unit, insert the key (K) into the lock (J) and turn
it one quarter turn counterclockwise. Then remove the key.
□ To unlock the unit, insert the key (K) into the lock (J) and
turn it one quarter turn clockwise. Then remove the key.
K
3
Opening the top chest lid
□ Open the top chest lid to 90 degrees first.
□ Push it into the top chest's inside-bottom.
IMPORTANT : The lid must be fully closed before
moving the unit.
2
Removing/installing the drawers
Removing the drawers -
□ Fully extend and empty the drawer.
□ On the slide, lift up the plastic release lever on one slide
and push down the plastic release lever on the other slide.
Gently pull the drawer out so the
slides can ride over the stops.
Installing the drawers -
□ Pull the slides and slide carrier out until fully extended.
□ Hold the slide on the cabinet while aligning it with
the slide on the drawer.
□
Slightly insert one side and repeat for the other side.
□ Slowly push the drawer until it is fully closed to
engage the slide.
□ Open the drawer and close it
to verify proper operation.
4
Installing the LED work light
□ Connect the USB wire with the adapter.
□ Plug in the magnetic LED work light (R) on tool chest for
extra light.
□ Press the button on the LED light to turn the light on for use.
9
Pleas e contac t 1-888-HD-HUSK Y fo r furthe r assistance .
R
HUSKYTOOLS.COM