Advertisement
Quick Links
Pre Assembly
-
TOOLS REQUIRED
Phillips
screwdriver
HARDWARE INCLUDED
NOTE: Hardware not shown to actual size.
AA
Part
Description
AA
Screw M6x12L
BB
Washer M8
CC
Bolt M8x20L
SPECIFICATIONS
Maximum capacity (drawers)
Empty weight
Maximum product weight including contents
,
NOTE: Begin product assembly close to the final
intended location of your tool cart This
heavy and may be difficult to move after assembly.
Safety
goggles
BB
Quantity
32
16
16
product is
.
13 mm
Wrench
CC
150
lbs
.
77
lbs
.
500
lbs
.
4
Advertisement
Related Manuals for Husky HOTC8010BB1S
Summary of Contents for Husky HOTC8010BB1S
- Page 1 Pre Assembly TOOLS REQUIRED Phillips Safety 13 mm screwdriver goggles Wrench HARDWARE INCLUDED NOTE: Hardware not shown to actual size. Part Description Quantity Screw M6x12L Washer M8 Bolt M8x20L SPECIFICATIONS Maximum capacity (drawers) Empty weight Maximum product weight including contents NOTE: Begin product assembly close to the final intended location of your tool cart This product is...
- Page 2 Pre Assembly (continued) PACKAGE CONTENTS Part Description Quantity Part Description Quantity Rigid caster Wood top Key (set) Side handle Drawer Legs Lock Swivel caster with brake Husky badge Tray Drawer slide (pair) HUSKYTOOLS COM Please contact 1-888-43-HUSKY for further assistance .
-
Page 3: Installing The Legs
Mount the four legs (C) to the cart using six screws AA per leg. Do not install four of the screws (AA) in the legs of the tool cart on the side adjacent to the Husky badge (K). The side handle (B) will be mounted here in a later step. - Page 4 Attaching the side handle NOTE: The holes in the tool cart are tapped and do not require nuts. □ □ Attach the side handle (B) to the tool cart using four screws (AA). HUSKYTOOLS COM Please contact 1-888-43-HUSKY for further assistance .
-
Page 5: Operation
Operation Locking and unlocking the unit Removing the drawers □ Fully extend and empty the drawer . IMPORTANT : The drawers must be fully closed before □ Depending on the slide either lift or lower the locking / unlocking the unit. release lever on both sides so the slides can ride over □... -
Page 6: Maintenance
Maintenance Maintaining the casters Maintaining the drawers □ Periodically clean the drawer trim and □ Grease the casters annually using high quality inside the drawers with a mild detergent and water . bearing grease . □ Remove grease and oil with a standard , nonflammable cleaning fluid .