Table of Contents
Advertisement
Placing the electronic limit switch into operation using its default settings – Switching voltage must
be applied.
Initial reading
(electronic limit
switch not initialized)
P1: Reading
direction
[1234]
P4: Actuator type
[ROT]
P5: Actuator's
direction of action
[PTO]
P6: Switching func-
tion of contacts A, B,
C
[NC]
P7: Switching
contact, lower end
position
[2.0 %]
P8: Switching
contact, upper end
position
[98.0 %]
Gray background: RUN operating mode (operation, parameters cannot be changed)
EB 8390 EN
%
%
: Turn
: Press
Initial reading
(electronic limit
switch initialized)
%
Change to RUN
mode
Enter key number:
If the wrong key
number is entered,
the mode does not
change.
Initialization success-
fully completed
Partial stroke test
%
(PST) can be config-
ured (see sec-
tion 9.2)
Initialization in
progress
Six seconds
P9: Automatic
initialization
39
Advertisement
Table of Contents
