Maytag MHW5630HW Installation Instructions Manual page 52

REVERSE DOOR SWING: SQUARE-SHAPED DOOR
1.
Remove door from dryer
Using a T25 screwdriver , remove the four screws securing the
®
door hinge to the dryer and lift up and out to remove
the door . Place the door on a soft towel or other non-scratch
surface. Retain or set aside the four screws.
2.
Move the door strike
Using a T25 screwdriver , remove the two screws securing
®
the door strike to the door frame of the dryer . Remove the four
screws above and below the door strike and set aside for later
use. Rotate the strike 180° and attach to the opposite side of
dryer door frame, as shown.
28
3.
Remove inner door from outer door
Release tab
Position the door with the inside of the door facing up. Using
a Phillips screwdriver , remove the 13 screws securing the inner
door to the outer door . Lift off the inner door and set aside.
NOTE: There is a small release tab on each side of the door . If the
inner and outer door do not separate easily, slide a credit card,
putty knife, or similar flat object between the inner and outer
doors at the locations shown to release the tab.
4.
Remove hinge and latch
from inner door
Hinge
Using a T25 screwdriver , remove the three screws securing the
®
latch plate and the five screws holding the hinge assembly in
place.
Release tab
Latch