Suggested Solutions For Problems - Beko DCU 7670 Manual

6

Suggested solutions for problems

Drying process takes too much time
• Cover filter and filter drawer might have not been cleaned. Clean the cover filter and filter drawer.
Laundry comes out wet at the end of drying.
• Cover filter and filter drawer might have not been cleaned. Clean the cover filter and filter drawer.
• Excessive laundry might have been loaded in. Do not load the dryer in excess.
Dryer does not switch on or the programme does not start. Dryer is not activated when set.
• It might have not been plugged in. Make sure that the machine is plugged in.
• The loading door may be ajar. Make sure that the loading door is properly closed.
• Programme might have not been set or the "Start/Pause/Cancel" button might have not been
pressed. Make sure that the programme has been set and it is not in "Pause" mode.
• "Childproof lock" might have been activated. Deactivate the childproof lock.
• The condenser cover on the models with a condenser might not be closed securely. Make sure
that the condenser cover and the red lock is closed securely.
Programme has been interrupted without any cause.
• The loading door may be ajar. Make sure that the loading door is properly closed.
• Electricity may be cut off. Press "Start/Pause/Cancel" button to start the programme.
• Make sure that the condenser cover and the red lock is closed securely.
Laundry has shrunk, become felted or deteriorated.
• A programme suitable for the laundry type might have not been used. Dry only the laundry
which is suitable for drying in dryer after checking the labels on your clothes.
• Select a programme with suitable low temperature for the laundry type to dry your clothes.
Drum lightning does not come on. (For models with lamp)
• Dryer might have not been started by using the "On/Off" button. Make sure that the dryer is on.
• Bulb may have blown. Call the authorized service to replace the bulb.
"Final / Anti-creasing" LED flashes.
• The 2-hour anti creasing programme to prevent laundry from creasing might have been acti-
vated. Turn off the dryer and take out the laundry.
"Final / Anti-creasing" LED is on.
• Programme has come to an end. Turn off the dryer and take out the laundry.
The "Drying" LED flashes.
• A heat sensor failure has occurred. Dryer ends the programme without heating. Turn off the
dryer and take out the laundry. Call your authorized service.
For products with a condenser:
"Water tank" warning LED is on.
• Water may be full.
• Anti-creasing programme might be running. Drain the water in the tank.
"Filter cleaning" LED is on.
• Filter might have not been cleaned. Clean the cover filter.
"Condenser cleaning" LED is on.
• Filter drawer/Condenser might have not been cleaned. Clean the filters in the condenser/filter
drawer under the kick plate.
A
Call an authorized service if the problem persists.
74 EN