Adjusting Feet; Electrical Connection - Beko DCU 7670 Manual

Connecting the water drain hose for
models with the water tank at the
bottom;
Connection pipe to water drain is at the bottom
rear of your machine.
1. Remove the bracket and the rubber cap.
2. Attach the drain hose and replace the bracket
to its position.
Important:
C
Make sure that the discharge hose is tight
after it is connected to the drain in order to
obtain a better water flow since the machine
is not equipped with a pump. You can cut
and shorten the hose to adjust its length if
necessary.
C The end of the hose should never be higher
than the level of the water outlet on the
machine. Otherwise, the "tank full" light of
your machine will illuminate and stop the
programme.
C If the dryer is mounted on the washing
machine by means of a bracket, use of the
water drain hose is recommended. The drain
hose should be directed downwards as
shown in the figure.

Adjusting feet

In order to ensure that your product operates
more silently and vibration-free, it must stand
level and balanced on its feet. Front feet of your
product can be adjusted. Balance the machine
by adjusting the feet.
1. Loosen the feet by hand.
2. Adjust the feet until the product stands level
and firmly on the floor.
C
Do not use any tools to loosen the adjustable
feet, otherwise, they can be damaged.
C
Never remove the adjustable feet from their
housings.
2 plastic pieces supplied along with the user
manual prevent your machine from slipping
on wet and slippery surfaces. To install the
plastic parts:
1. Tilt your product to backwards.
2. Fit the plastic parts on to the front adjustable
feet. Press on the plastic parts to snap
them into their seating.
3. Check the balance of your product
again and readjust the adjustable feet if
necessary.

Electrical connection

Connect the machine to a grounded outlet
protected by a fuse of suitable capacity as
stated in the technical specifications table. Our
company shall not be liable for any damages
that will arise when the machine is used on a
circuit without grounding.
• Connection must comply with national
regulations.
• If the current value of the fuse or breaker
in the house is less than 16 Amps, have a
qualified electrician install a 16 Amp fuse.
• Power cable plug must be within easy
reach after installation.
• The voltage and allowed fuse or breaker
protection are specified in the "Technical
Specifications" section.
• The specified voltage must be equal to
your mains voltage.
• Do not make connections via extension
cables or multi-plugs.
• The main fuse and switches must have a
contact distance of minimum 3 mm.
B
Damaged power cable must only be
replaced by a qualified electrician.
B
If the product is faulty, it must not be
operated unless it is repaired! There is the
risk of electric shock!
First use
• To have the product ready for operation
before calling the authorised service agent,
make sure that its location and power
supply installations are appropriate. If they
are not, call a qualified electrician to have
any necessary arrangements carried out.
• Make sure that the power connections of
the product are in accordance with the
instructions given in relevant chapters of
this manual.
Disposing of packaging material
Packaging materials are dangerous to children.
Keep packaging materials in a safe place out
of reach of children. Packaging materials of
your product are manufactured from recyclable
60 EN