Warning Indicators - Beko DCU 7670 Manual

Programme duration can change depending on
the selection.
A
This function must be selected before the
programme starts.
Anti-creasing
A 2-hour anti creasing programme to prevent
laundry from creasing will be activated if you do
not take the laundry out after the programme
is over. This programme rotates the laundry in
600-second intervals to prevent creasing. Press
"Anti-creasing" button to activate.
Anti-creasing is activated but the programme
is running in the first exemplary figure. Drying
is over and the first step of anti-creasing has
started in the second figure.
Changing the contrast
Contrast can be adjusted in order to make
the symbols on the display appear clearer. It
may particularly be necessary to change the
contrast setting of the display when the dryer is
installed over a washing machine.
Press and hold the Spin Speed/Time button for
3 seconds.
When the contrast is changed at the end of
3 seconds, all symbols on the display will
become visible for 3 seconds in order to
indicate that the process is complete.
Perform the same procedure to revert back to
the previous contrast setting.

Warning indicators

C
Warning indicators may differ according to
the model of your machine.
Filter cleaning
A warning symbol will appear to remind filter
cleaning after the programme finishes.
C
f the filter cleaning symbol flashes
continuously, please refer to "Suggested
solutions for problems".
Water tank
A warning symbol will turn on at the end of
the programme or when the tank is full with
water. The machine stops operating if the
warning symbol turns on when a programme
is running. To restart the machine, please drain
the water in the water tank. Press "Start/Pause/
Cancel" button to start the programme after
you have emptied the water tank. The warning
symbol turns off and the programme resumes
operating.
Cleaning the condenser
Warning symbol turns on with certain intervals
to remind that the condenser needs cleaning.
Door open
Door of the dryer may be open. Latch of the
condenser may be open.
Time delay
With the "Time delay" function you can delay
the programme start up to 24 hours.
1. Open the loading door and put the laundry
in.
2. Set the drying programme and spin speed,
and if required, select the auxiliary functions.
3. Press "Time delaying" buttons "+" and "-" to
set the desired time delay. The time delay
symbol will flash.
4. Press "Start/Pause/Cancel" button. Then the
time delay starts to count down. The Time
delay symbol lights up. Start symbol lights
up.
The ":" in the middle of the displayed time delay
will start flashing.
More laundry may be loaded or taken out
during the time delay period. At the end of the
time delay countdown process, time delay
symbol fades, drying process starts and the
programme duration is displayed. The time on
the display is the total of normal drying time
and delay time.
Time delay is started by pressing the start/
pause/cancel button in the exemplary figure.
Changing the delay time
If you want to change the time during the
countdown:
1. Press "Start/Pause/Cancel" button for 3
seconds to cancel the programme. Time
delay function must be set again for the
69 EN