Table of Contents
Advertisement
GA-686NX
3.12. PERIPHERAL DEVICE INSTALLATION
After the I/O device installation and jumpers setup, the mainboard can be mounted
into the case and fixed by screw.
To complete the mainboard installation, the peripheral device could be installed now.
The basic system needs a display interface card.
If the PCI - Bus device is to be installed in the system, any one of four PCI - Bus slots
can be used if Slave PCI - Bus device being installed; any one of four PCI-Bus slots
can be used if Bus Master PCI-Bus device being installed.
3.13. KEYBOARD & PS/2 MOUSE INSTALLATION
The main board supports PS/2 connector type keyboard (CN3) & Mouse (CN4).
The BIOS will auto detect wheather the PS/2 Mouse is installed or nor & assign
IRQ12 for Mouse port if which was installed.
After installing the peripheral device, the user should check everything again, and
prepare to power-on the system.
3.14. KEYBOARD SETTING FUNCTION
After booting the O.S., there are some special functions used by keyboard as follows:
"CTRL_ALT_DEL"
-
Pressing these keys simultaneously will cause
system to Warm Start (Software Reset).
3-12
Advertisement
Table of Contents
