Installation - Heath Zenith DualBrite 4169 Installation And Operating Instructions Manual

instaLLatiOn

WarninG: turn power off at circuit
breaker or fuse.
For best performance, mount the fixture about 6
feet (1.8 m) above the ground.
1. Remove two decorative nuts.
2. Remove mounting plate.
3. Tighten mounting screws finger tight.
4. Set sensitivity control on back of fixture to
mid-position.
5. Attach mounting plate to junction box.
Decorative Nut
Ground Screw
Wire Path
Bracket
Mounting
Screws
Note: We recommend having an assistant help hold
the lantern assembly during the wiring process.
Mounting
Plate
Mounting Screw
SENS
MIN MAX
Junction
Box
Mounting Plate
This fixture comes with a universal mounting
bracket. It is pre-assembled on the fixture to fit
the majority of junction box applications.
However, if the slots on the mounting plate do not
line up with the junction box screw holes:
1. Remove the fixture mounting screws from
the mounting plate. Note: Do not remove the
ground screw.
2. Attach ground wire " pigtail" to ground screw on
mounting plate (See Recommended Grounding
Method for additional information).
3. Flip the mounting plate over.
4. Rotate the mounting plate so the wire path
is on the upper right. Note: The wire path on
the mounting plate must be located as shown
below to allow the wires on the back of the
fixture to pass through.
5. Reinstall the fixture mounting screws and at-
tach the mounting plate to the junction box
as shown.
Wire Path
As Shipped
2
Ground Screw
Fixture Screws
Flipped and
Rotated
Wire Path
200472-01