Installation - Graco 257369 Repair Manual

Clutch Armature
8. Use an impact wrench or wedge something
between clutch armature (25) and clutch housing to
hold engine shaft during removal.
ti5483a
9. Remove four screws (23) and lock washers (24).
10. Remove armature (25).

Installation

Clutch Armature
1. Lay two stacks of two dimes (or 1.4mm coins) on a
smooth bench surface.
2. Lay armature (25) on two stacks of coins.
3. Press center of hub (26) down to bench surface.
313889E
25
24
23
26
25
ti6321a
Pinion Assembly / Clutch Armature / Clamp
Clamp Removal
Gasoline can spill and cause a fire or explosion if engine
is tipped on its side.
1. Remove Engine, page 19, and drain gasoline from
tank according to Honda manual.
2. Tip engine on side so gas tank is down and air
cleaner is up.
ti13250a
3. Use 3/16 in. hex key wrench to loosen two screws
(23) on clamp (22).
22
4. Push screwdriver into slot in clamp (22) and remove
ti6199b
15