= Off (factory default)
= Low
Conditions
The Low option should only be set if the
water used for washing the laundry is
extremely soft with a conductivity read-
ing (electrical conductivity) less than
150 μS/cm. Contact your local water
authority for the conductivity level of
your mains water supply.
Make sure that you only activate
for the condition described
above.
Otherwise drying results can be un-
satisfactory.
Programmable functions
Control panel switch-off
status
To save energy the time display and
sensor controls will go out after 10
minutes, and only the Start/Stop
sensor will be left flashing. You can al-
ter this setting.
However, there is no switch-off in the
event of a fault.
Options
= off
The time display and sensors
will remain lit up while the dryer
is switched on.
= on (default setting)
The time display and sensors
will go out after 10 minutes . . .
. . . if no further selection is
made after switching the dryer
on.
. . . after a programme has
started.
However: the time display and
sensors will remain lit up for 10
minutes after a delay start time
has elapsed, after the end of
the programme or at the end of
the anti-crease phase.
"Switch on" display again
– Turn the programme selector (not to
) or press a sensor control. Neither
will have any effect on a programme
which is running.
– Open the door while the dryer is
switched on.
71