Table of Contents
Advertisement
Problem solving guide
Problem
A programme does not
start
Only the Start/Stop
sensor is now flashing
The dryer switches off
at the end of the pro-
gramme
The interior drum light-
ing does not come on
52
Cause and remedy
No obvious cause.
Connect the tumble dryer to the mains
Turn on the tumble dryer
Close the door
Check whether the mains fuse has tripped
Has there been a power cut? When power is restored
any previously running programme will restart auto-
matically.
10 minutes after the end of the programme, the Start/
Stop sensor will begin to flash and the display will go
out: energy saving. This is not an error but a normal
function.
The drum will turn at intervals in the anti-crease
phase.
Touch a sensor to switch on the indicators.
See the "Programmable functions", chapter, " Con-
trol panel switch-off status" section.
The dryer switches off automatically: energy saving.
This is not an error but a normal function.
To switch the dryer on, select a programme.
Tip: you can change this. See the "Programmable
functions", chapter, " Dryer switch-off status" sec-
tion.
The drum lighting will switch off automatically ...
... when the door is closed.
... after a few minutes when the door is open (to save
energy).
If the dryer is switched on, the drum lighting will
come on when the door is opened.
Advertisement
Table of Contents
