Table of Contents
Advertisement
End of programme/Anti-crease
Programme end: lights up and the
Start/Stop sensor goes out.
Following the end of the programme,
the Anti-crease phase is activated for
max. 2 hours. There is no Anti-crease
phase with Woollens handcare.
See "Programmable functions", "
Anti-crease".
Energy saving:
– 10 minutes after the end of the pro-
gramme, the Start/Stop sensor will
begin to flash and the display will go
out.
– The dryer will switch off automatically
15 minutes after the end of the anti-
crease phase (with programmes
without an anti-crease phase it will
switch off 15 minutes after the end of
the programme).
Remove the laundry
Never open the door before the
drying process has finished.
Reach under the door grip and pull
the door open.
4. Remove the laundry
Unload the drum.
Check that all items have been re-
moved from the drum.
If items are left in the dryer, they
could be damaged by over-drying
when the dryer is next used.
Turn the programme selector to .
A signal sounds as long as the dryer
does not switch off automatically.
Remove the fluff from the 2 fluff filters
in the door opening: see the "Clean-
ing and care - Fluff filters" chapter.
Shut the door with a gentle swing.
Empty the condensed water con-
tainer.
Drum lighting
The inside of the drum lights up so that
you don't forget any items of laundry
when you empty it.
The drum lighting switches off automat-
ically (energy saving).
29
Advertisement
Table of Contents
