Toshiba PORTEGE R300 Maintenance Manual page 249

4.7 Keyboard
Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figure 4-6 to Figure 4-9.
1. Place the keyboard face down on the palm rest.
2. Connect the keyboard cable to the connector CN3230 on the system board.
3. Install the keyboard support plate and secure it with the following screw.
• M2×12BS
4. Turn the keyboard face up and set it in place.
5. Secure the keyboard with the following screws.
• M2×2.5B
CAUTION: Make sure the FPC does not touch the cover-rib.
6. Install the keyboard holder (L/R) and touch pad mask and press to secure the
latches.
NOTE: Stick the insulator to the keyboard cable if the new keyboard is installed.
PORTÉGÉ R300 Maintenance Manual (960-591)
All manuals and user guides at all-guides.com
S-THIN HEAD screw
S-THIN HEAD screw
Figure 4-9 Installing the keyboard
4 Replacement Procedures
×1
×2
Insulator
[CONFIDENTIAL] 4-17