Table of Contents
Advertisement
Maintenance: Floor Brush Roll
1
Ensure vacuum is unplugged.
Place handle in low position,
remove hose from foot and
turn vacuum over bottom side
up. Remove 6 screws with a
Phillips head screwdriver. Lift
brush cover off of the vacuum.
Maintenance: Drive Belt
1
With rotating brush removed
(steps 1-3 maintenance floor
brush roll), grasp old drive belt
and remove from motor pulley.
Maintenance: Cleaning the Dirt Tank
1
With the top handle
removed, wash the dirt
tank in warm water
with mild detergent.
Allow tank to air dry.
2
Grasp rotating floor
brush at both ends and
lift straight out of the
vacuum foot. Slip off
the belt.
2
Place new belt over
motor pulley and
stretch other end
over the floor brush.
2
Twist top handle from the round
separator counterclockwise to
release. Wash in warm water with
mild detergent. Dry completely
before reassembling.
3
Clean debris from rotating
floor brush, motor
pulley, drive belt and air
passageway areas.
3
Place ends of rotating floor
brush down into slots.
Reposition bottom cover and
replace all 6 screws.
3
Align tabs to return
separator to top handle.
Align latch arrows and
twist tank clockwise
until "clicks" into place.
www.BISSELL.com
9
Advertisement
Table of Contents
