Bissell MOMENTUM 1792P Series User Manual page 8

Maintenance: Pre-Motor Filter
1
Remove the dirt tank to
locate and remove the
pre-motor filter. Pinch
the filter and lift to
remove from unit.
WARNING
To reduce the risk of electrical shock, turn power switch off and disconnect polarized plug
from electrical outlet before performing maintenance or troubleshooting checks.
Maintenance: Post-Motor Filter
1
Located on the front near the height
adjustment knob, remove filter door by
pressing and pulling latch downward.
3
Replace filter in unit with
handle facing you. Replace
the door by hooking the
bottom into the grooves
and rotate towards unit,
snapping into place.
WARNING
Do not operate vacuum with damp or wet filters, as well as without filters or the Dirt
Container in place. Allow components to dry before reassembling the Dirt Container.
8
www.BISSELL.com
2
While holding over trash,
gently separate filter layers
(being careful not to rip
filter layers) and shake out
excess debris.
2
NOTE: Filter can be
rinsed in warm water.
Allow it to completely
dry before replacing. If
the filter is damaged,
replace the part.
NOTICE:
Your vacuum model
includes a Febreze® filter.
Over time with washing,
you will notice a reduction
in the scent strength.
Remove the filter
by grasping the
handle on the front
of the filter and
pulling out from
vacuum. Clean,
wash, or replace
filter, as necessary.
NOTE: The pleated post-
motor filter may NOT be
washed with water or
detergent. If dust and/or
debris accumulates on filter,
gently tap the filter on the
side of a garbage container.