Subaru Outback 2012 Manual page 161

3-42
Instruments and controls
NOTE
Some garage door openers may re-
quire you to do the above press-hold-
release sequence a third time to com-
plete the programming.
4. The garage door opener should now
recognize the HomeLink Wireless Control
®
System and your garage door opener
should activate when the HomeLink
button is pressed.
! Programming for entrance gates and
garage door openers in Canada
1. Unplug the motor of the entrance gate
or garage door opener from the outlet.
NOTE
If any of the HomeLink
®
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
®
1) HomeLink
2) HomeLink
3) HomeLink
2. Press and hold the two outer
HomeLink
®
buttons are
3) until the HomeLink
begins to flash (after approximately 20
seconds). Then release both buttons.
3. Hold the end of the entrance gate's/
garage door opener's hand-held transmit-
ter between 1 and 3 inches (25 and 76
mm) away from the HomeLink
wish to program.
4. Press and hold the desired HomeLink
button.
5. Press and release ("cycle") the hand-
held transmitter button every 2 seconds
until step 6 is complete.
button 1
®
button 2
®
button 3
®
buttons (button 1 and button
indicator light
®
button you
®
6. When the indicator light flashes slowly
and then rapidly after several seconds,
release both buttons.
7. Plug the motor of the entrance gate/
garage door opener to the outlet.
8. Test your entrance gate/garage door
opener by pressing the programmed
HomeLink button.
®
! Operating the HomeLink
Control System
Once programmed, the HomeLink
less Control System can be used to
remote-control the devices to which its
buttons are programmed. To activate a
device, simply press the appropriate but-
ton. The indicator light illuminates, indicat-
ing that the signal is being transmitted.
! Programming other devices
To program other devices such as door
locks, home lighting and security systems,
contact HomeLink at www.homelink.com
®
or call 1-800-355-3515.
! Reprogramming a single HomeLink
button
®
1. Press and hold the HomeLink
you wish to reprogram. DO NOT release
the button until step 4 has been com-
pleted.
2. When the HomeLink
Wireless
®
Wire-
®
®
button
®
indicator light
®