Sharp XG-K230XA Manual page 190

The setting procedure for each item will be explained. For the basic procedure, please refer
to "Set Items" on page 23.
IP Address Setting
([1]IP Address)
Setting of IP address.
1 1 1 1 1 Enter "1" and press the "Enter" key.
2 2 2 2 2 Enter numerical value to be set and press the
"Enter" key.
Display IP address after change (*).
Subnet Mask Setting
Subnet Mask)
Setting subnet mask.
1 1 1 1 1 Enter "2" and press the "Enter" key.
2 2 2 2 2 Enter numerical value to be set and press the
"Enter" key.
Display subnet mask after change (*).
Setting up the Projector Using RS-232C or Telnet
Default Gateway Setting
([3]Default Gateway)
Setting default gateway.
1 1 1 1 1 Enter "3" and press the "Enter" key.
2 2 2 2 2 Enter numerical value to be set and press the
"Enter" key.
Display gateway address after change (*).
([2]
• If the values for IP Address, Subnet Mask or Gate-
way of the projector have been changed via Telnet,
the computer cannot be connected to the projec-
tor depending on the computer's network settings.
User Name Setting
([4]User Name)
Carrying out security protection using user name.
1 1 1 1 1 Enter "4" and press the "Enter" key.
2 2 2 2 2 Enter user name and press the "Enter" key.
Display set user name (*).
• User name can be up to 8 characters.
• You can input the characters below :
a-z, A-Z, 0-9, -, _
• In the default state, user name is not set.
-25