Sharp XG-K230XA Manual page 128

Table of Contents

Advertisement

Image Projection (Continued)
3 Adjusting the Height
The height of the projector can be ad-
justed using the adjustment feet at the
front and rear of the projector.
When the screen is above the projector,
the projection image can be made
higher by adjusting the projector.
1
Lift the projector to adjust its
height while lifting the HEIGHT
ADJUST lever.
2
Remove your hands from the
HEIGHT ADJUST lever of the pro-
jector after its height has been
finely adjusted.
• The angle of projection is adjustable up
to 9 degrees from the surface on which
the projector is placed.
3
Use the rear adjustment foot to
make the projector level.
• The projector is adjustable ± 2 degrees
from the standard position.
• When adjusting the height of the projector,
trapezoidal distortion occurs. Follow the pro-
cedures in Keystone Correction to correct the
distortion. (See pages
• Do not apply too much pressure on the pro-
jector when the front adjustment foot comes
out.
• When lowering the projector, be careful not to
get your fingers caught in the area between
the adjustment foot and the projector.
• Hold the projector firmly while lifting or carrying.
• Do not hold by the lens area.
28
29
and 44.)
HEIGHT
ADJUST lever
Make small
adjustments.
Rear adjustment foot

Advertisement

Table of Contents
loading

Table of Contents