Table of Contents
Advertisement
en Troubleshooting
17.2 Rinsing
If you have not used the steam function for a long time,
descale and rinse the appliance.
To ensure that your appliance stays clean, you can
pump water through the pipe system. The appliance
then drains the water into the drip tray.
Note: After running the rinse cycle, loosened limescale
particles may be in the drip tray. This is normal and
does not affect operation.
Running the rinse cycle
1.
Use the function selector to select .
a The display shows the programme duration. You
cannot change the programme duration.
18 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
If the appliance is defective, call Customer Service.
18.1 Malfunctions
Fault
The appliance is not
working.
lights up in the
display and no set-
tings can be made
on the appliance.
The interior lighting is
not working.
12:00 flashes in the
display and the
symbol lights up.
30
Cause and troubleshooting
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
Malfunction
1.
Switch off the fuse in the fuse box.
2.
Switch the fuse back on after approx. 10 seconds.
a If the fault was a one-off, the message disappears.
3.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→ "Customer Service", Page 33
Door is not fully closed.
▶
Check whether food remains or foreign material are trapped in the door.
Childproof lock is activated.
▶
Press and hold
until
The LED lamp is defective.
▶
If this fault recurs, call the after-sales service.
There has been a power cut.
▶
Reset the time.
→ "Setting the time", Page 25
2.
Open the tank cover.
3.
Remove the drip tray and empty it.
4.
Slide the empty drip tray in fully.
5.
Remove and empty the water tank and drain any re-
sidual water.
6.
Rinse out the water tank thoroughly and fill it with
fresh water.
7.
Slide the water tank in fully.
8.
Close the tank cover.
9.
Press
.
a Water is pumped through the pipes.
a The time remaining counts down in the display.
a An audible signal sounds once this time has
elapsed.
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
Only use genuine spare parts when repairing the
appliance.
▶
If the power cord of this appliance is damaged, it
must be replaced by the manufacturer, the manufac-
turer's Customer Service or a similarly qualified per-
son in order to prevent any risk.
goes out.
Advertisement
Table of Contents
