Hunter Sandin Installation Manual page 9

Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Insert the third screw, found in the
bag, in place and firmly tighten all the three screws.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Install the included bulbs into the
sockets. When necessary, replace
with bulbs of same wattage.
Note:
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
Fan style may vary.
sure that glass is properly secured.
Ceiling Bracket Downrod
Assembling the LIght Kit
2 of 3
Light Kit Screw
bag
Feed the 9-pin plug connector coming
from the bottom of the motor housing
through the center hole in the light kit
assembly. Connect it to the plug connector
found in the switch housing area of the
light kit assembly. Make sure to line up
the colored markings on the connectors.
1 of 3
Light Kit Screw
bag
hardware
Note:
Fan style may vary.
Installing the Bulbs and Glass
Tab
Notch
Lift the globe and align the notches
in the globe with the tabs in the
light kit.
WARNING
Hanging Fan Wiring
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Wrap the keyhole slots around the
screws and twist counterclockwise.
Carefully push all switch housing components into the switch
housing, then install the switch housing plate using two short light
kit assembly screws, found in the
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Canopy Blades
2 of 2
Short Light Kit
Screw
bag
hardware bag.
NOTE: Check to ensure
proper engagement.
Light Glass/Bulbs
1886
ON
8