Related Manuals for Hunter Sturridge II
Summary of Contents for Hunter Sturridge II
- Page 1 Sturridge II Installation Manual Model: 50606 Noble Bronze 51627 Matte Silver Fan weight ±2 lbs: 30.6 lbs (13.9 kg) ©2021 Hunter Fan Co. PG3814 r092421...
- Page 2 - All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 3 We recommend that you pull everything out of the box and lay it out. We have grouped the drawn components below with the hardware you’ll need for those Hunter Pro Tip: parts. The screws below are drawn to scale to make it easier to identify what piece of hardware is needed to install each component.
-
Page 4: Choosing The Right Installation Location
A little more information on Angled Mounting: For optimum performance and appearance, a longer downrod should be used with your Hunter ceiling fan when installing on high or angled ceiling. If your ceiling is angled greater than 34° you will also need an Angled Mounting Kit. -
Page 5: Installing The Ceiling Bracket
You have two options for installation. Pick which one works best for your location. Remove any existing Hunter Pro Tip: bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box. The machine screws are the ones that came with your outlet box. -
Page 6: Hanging The Fan
To prevent SERIOUS INJURY or DEATH: • ALWAYS tighten setscrew with pliers. Hunter Pro Tip: • DO NOT hand tighten setscrew. • CHECK the setscrew is tight using pliers The ground wire attached to the each time you change fan direction. -
Page 7: Wiring The Fan
Follow these steps to get your fan wired quickly and safely. Follow the route below that best matches your wall switch setup. If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualified electrician. Hunter Pro Tip: NOTICE... -
Page 8: Installing The Canopy
1886 Installing the Canopy Insert the two canopy screws found in the hardware bag. Canopy Screw Lift the canopy into place so that the screw holes are aligned. Installing the Blades: Secure each blade to a blade iron as shown using the blade nuts, found in the hardware bag, and the blade assembly screws, found in the hardware bag. -
Page 9: Assembling The Light Fixture
1886 Assembling the Light Fixture 2 of 3 Align the keyhole Light Kit Screw slots in the top of the light kit WARNING assembly with the partially installed assembly screws. FAN FALL HAZARD Wrap the keyhole Make sure all three screws are tight to secure slots around the the trim ring to the mounting plate. -
Page 10: Preparing The Remote Control
1886 Preparing the Remote Control The remote control is already paired for use. NOTICE • Always purchase the correct size and grade of battery most suitable for the intended use. • Clean the battery contacts and also those of the Battery Door device prior to battery installation. -
Page 11: Troubleshooting
• Make sure the blades are properly installed. • Check to see if any of the blades are cracked. If so, replace all of the blades. Hunter Pro Tip: Cleaning the Fan Use soft brushes or cloths to prevent scratching. -
Page 12: Limited Lifetime Warranty
Hunter instructions, accidental damage caused by the fan owner or related parties, Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. modifications to the fan, improper or incorrectly performed maintenance or repair,...