Install Fire Detector - Honeywell ESSER 781443 Installation Instructions Manual

Venturi-Air Duct Kit

11.2 Install fire detector

blue
The OT -LKM (Part No. 802379) must be aligned to the detector base and mounted by turning the detector
clockwise into the base until it engages. It is recommended to use the removal tool (Part No. 805580) to
insert/remove the detector from the base.
blue
The IQ8Quad OT -LKM is connected and powered via the loop of the Fire Alarm Control Panel.
Alarm and fault messages are transmitted via the loop to the connected Fire Alarm Control Panel and indicated
on the panels display (text and/or 3-digit fault code).
An activated alarm is also local indicated with the flashing red detector LED
mounted detectors in the air duct kit through the transparent cover.
EP6
1
OUT5
EM2
IN4
C3
Fig. 24: Insert multisensor detector
•
An external remote indicator (e.g. Part No. 801424) may be connected if required.
•
It is recommended to use the removal tool (Part No. 805580) to insert/remove the detector from the base.
•
Fix flow indicator (supplied Film strip) inside the cover (refer to Fig. 25).
•
Replace cover in correct positional arrangement.
Fig. 25: Flow indicator (Film strip)
Please refer to the manuals of the Fire Alarm Control Panel and components for additional
information.
34
. The LED is even visible for the
1
FB 798349 / 04.13