Table of Contents
Advertisement
Administrator Information
11. Click Transmit.
12. Click OK on the confirmation message.
The settings are sent to the printer.
13. On the sending completion screen, click OK.
The printer's information is updated.
Open the contacts from Web Config or printer's control panel, and then check that the contact is updated.
Cooperation between the LDAP Server and Users
When cooperating with the LDAP server, you can use the address information registered to the LDAP server as the
destination of an email or fax.
Configuring the LDAP Server
To use the LDAP server information, register it on the printer.
1. Access the Web Config and select the Network tab > LDAP Server > Basic.
2. Enter a value for each item.
3. Select OK.
The settings you have selected are displayed.
Related Information
"Running Web Config on a Web Browser" on page 298
&
LDAP Server Setting Items
Items
Use LDAP Server
LDAP Server Address
LDAP server Port Number
Secure Connection
Certificate Validation
Search Timeout (sec)
>
Settings to Use the Printer
Select Use or Do Not Use.
Enter the address of the LDAP server. Enter between 1 and 255 characters of
either IPv4, IPv6, or FQDN format. For the FQDN format, you can use alphanumeric
characters in ASCII (0x20-0x7E) and "- " except for the beginning and end of the
address.
Enter the LDAP server port number between 1 and 65535.
Specify the authentication method when the printer accesses the LDAP server.
When this is enabled, the certificate of the LDAP sever is validated. We
recommend this is set to Enable.
To set up, the CA Certificate needs to be imported to the printer.
Set the length of time for searching before timeout occurs between 5 and 300.
379
>
Making Contacts Available
Settings and Explanation
Advertisement
Table of Contents
