Changing Boot/Network Parameters - HP Linux workstation x1100 Getting Started Manual

Hide thumbs Also See for Linux workstation x1100:

Table of Contents

Linux system setup and recovery

conﬁguring your Linux workstation

changing boot/network parameters

Choose the "Boot/Network" tab and the window below appears.

There are three kinds of booting protocols that

you: Static, DHCP, and BOOTP. Choose the appropriate protocol based

on the following descriptions:

1. Static boot protocol

If you choose Static booting, you will have to set several networking

parameters. Some of these are described below.

You will also need to provide an IP address for your workstation, a

hostname, the IP address of the network gateway for your system,

the netmask (255.255.248.0 for example), and a network domain

name (for example, company_name.com).

Press the "DNS Parameters" tab to set up your DNS Conﬁguration.

Refer to the section "DNS Parameters Conﬁguration" in this chapter

for an example of the screen interface and instructions.

After setting up DNS, click on the "Authorization Parameters" tab

and follow the instructions in the section "setting up network

authorization parameters."

can set up for

setparms

Chapter 2

Table of Contents