Braun cruZer2 Z40 Manual page 10

substances. Rinse off all foam and let the shaver run for a
few more seconds.
• Next, switch off the shaver, remove the shaver foil and the
cutter block. Then leave the disassembled shaving parts
to dry.
• If you regularly clean the shaver under water, then once a
week apply a drop of light machine oil onto the long hair
trimmer and shaver foil (g).
Alternatively, you may clean the shaver using the brush
provided (f):
• Switch off the shaver. Remove the shaver foil.
• Using the brush, clean the cutter block and the inner area
of the shaver head. However, do not clean the shaver foil
with the brush as this may damage the foil.
Keeping your shaver in top shape
Replacing the shaving parts
To maintain 100% shaving performance, replace your foil
and cutter block at least every 18 months or when worn.
Change both parts at the same time for a closer shave with
less skin irritation.
(Shaver foil and cutter block: 20R)
Preserving the batteries
In order to maintain the optimum capacity of the
rechargeable batteries, the shaver has to be fully discharged
(by shaving) every 6 months approximately. Then recharge
the shaver to full capacity.
Environmental notice
This product contains rechargeable batteries. In the
interest of protecting the environment, please do not
dispose of the product in the household waste at the
end of its useful life. Disposal can take place at a
Braun Service Centre or at appropriate collection
points provided in your country.
Subject to change without notice.
This product conforms to the European Directives
EMC 2004/108/EC and Low Voltage 2006/95/EC.
For electric specifications, see printing on the
special cord set.
11