Bed Lift Switch Removal; Bed Lift Switch Installation; Bed Lift Circuit Breaker; Testing The Bed Lift Circuit Breaker - Club Car Carryall 295 2013 Maintenance And Service Manual

13

Bed Lift Circuit Breaker

BED LIFT SWITCH REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Raise the hood.
3. Press the upper and lower retaining tabs and push the bed lift switch (9) out of the instrument panel (Figure
13-6, Page 13-7).
4. Disconnect the wire harness from the bed lift switch.

BED LIFT SWITCH INSTALLATION

1. Match the terminal numbers molded onto the connector and switch and reconnect the wire harness.
2. Push the bed lift switch into the instrument panel until fully seated.
3. Lower and secure the hood.
4. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.
BED LIFT CIRCUIT BREAKER

TESTING THE BED LIFT CIRCUIT BREAKER

See Test Procedure 37 – Bed Lift Circuit Breaker on page 11-37.

BED LIFT CIRCUIT BREAKER REMOVAL

1. Push the bed lift switch (9) out of the instrument panel. See Bed Lift Switch Removal on page 13-10.
2. Locate the bed lift circuit breaker (10) on the orange wire of the wire harness connected to the switch (Figure
13-6, Page 13-7).
3. Pull the circuit breaker out of the in-line fuse holder to remove.

BED LIFT CIRCUIT BREAKER INSTALLATION

Install the circuit breaker in the reverse order of removal.

LIGHT SWITCH

See General Warnings, Section 1, Page 1-2.
Page 13-10 2013 Carryall 295/XRT 1550 Maintenance and Service Manual
All manuals and user guides at all-guides.com
ELECTRICAL COMPONENTS: GASO-
LINE VEHICLES