Table of Contents
Advertisement
ELECTRICAL COMPONENTS: GASOLINE
VEHICLES
BED LIFT SWITCH
TESTING THE BED LIFT SWITCH
See Test Procedure 36 – Bed Lift Switch on page 11-40.
BED LIFT SWITCH REMOVAL
1.
Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2.
Raise the hood.
3.
Press the upper and lower retaining tabs and push the bed lift switch (9) out of the instrument panel (Figure
13-6, Page 13-6).
4.
Disconnect the wire harness from the bed lift switch.
BED LIFT SWITCH INSTALLATION
1.
Match the terminal numbers molded onto the connector and switch and reconnect the wire harness.
2.
Push the bed lift switch into the instrument panel until fully seated.
3.
Lower and secure the hood.
4.
Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.
BED LIFT CIRCUIT BREAKER
TESTING THE BED LIFT CIRCUIT BREAKER
See Test Procedure 37 – Bed Lift Circuit Breaker on page 11-40.
BED LIFT CIRCUIT BREAKER REMOVAL
1.
Push the bed lift switch (9) out of the instrument panel. See Bed Lift Switch Removal on page 13-9.
2.
Locate the bed lift circuit breaker (10) on the orange wire of the wire harness connected to the switch (Figure
13-6, Page 13-6).
3.
Pull the circuit breaker out of the in-line fuse holder to remove.
BED LIFT CIRCUIT BREAKER INSTALLATION
Install the circuit breaker in the reverse order of removal.
LIGHT SWITCH
See General Warnings, Section 1, Page 1-2.
2014 Carryall 295/XRT 1550 Maintenance and Service Manual
13
Bed Lift Switch
Page 13-9
Advertisement
Table of Contents
Troubleshooting
