Bed Lift Switch; Testing The Bed Lift Switch; Bed Lift Switch Removal; Bed Lift Switch Installation - Club Car Carryall 1500 2016 Maintenance And Service Manual

13

Bed Lift Switch

BED LIFT SWITCH

TESTING THE BED LIFT SWITCH

See Test Procedure 36 – Bed Lift Switch on page 11-40.

BED LIFT SWITCH REMOVAL

1. Disconnect battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery –
Gasoline/Diesel Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
2. Raise the hood.
3. Press the upper and lower retaining tabs and push the bed lift switch (9) out of the instrument panel (Figure
13-6, Page 13-7).
4. Disconnect the wire harness from the bed lift switch.

BED LIFT SWITCH INSTALLATION

1. Match the terminal numbers molded onto the connector and switch and reconnect the wire harness.
2. Push the bed lift switch into the instrument panel until fully seated.
3. Lower and secure the hood.
4. Connect battery and spark plug wire(s). See Side-Post Battery: Connecting the Battery – Gasoline/Diesel
Vehicles on page 1-4.
See Top-Post Battery: Connecting the Battery- Gasoline/Diesel Vehicles on page 1-4.

BED LIFT CIRCUIT BREAKER

TESTING THE BED LIFT CIRCUIT BREAKER

See Test Procedure 37 – Bed Lift Circuit Breaker on page 11-40.

BED LIFT CIRCUIT BREAKER REMOVAL

1. Push the bed lift switch (9) out of the instrument panel. See Bed Lift Switch Removal on page 13-10.
2. Locate the bed lift circuit breaker (10) on the orange wire of the wire harness connected to the switch (Figure
13-6, Page 13-7).
3. Pull the circuit breaker out of the in-line fuse holder to remove.

BED LIFT CIRCUIT BREAKER INSTALLATION

Install the circuit breaker in the reverse order of removal.
Page 13-10 2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
ELECTRICAL COMPONENTS: GASOLINE
VEHICLES