Use; Switching On And Off; Stapling/Nailing; Working With The Rip Fence - Parkside 331116 1907 Instructions Manual

Use

Switching on and off
♦ Set the ON/OFF switch
switch the appliance on.
♦ Set the ON/OFF switch
switch the appliance off.

Stapling/nailing

♦ Switch the appliance on by moving the ON/
OFF switch to the position "I".
♦ Press the face plate
the location on the material that you want to
staple/nail.
♦ Press the trigger
NOTE
► The integrated safety switch on the face plate
prevents accidental triggering.

Working with the rip fence

If you want to tack with nails or staples at a
constant distance to an edge, proceed as follows:
♦ Pull out the rip fence
arrow.
♦ Move the rip fence
is at the required distance from the edge of the
object that you want to work on.
♦ Place the rip fence
object that you want to work on.
♦ Proceed as described in the section Stapling/
nailing.

Troubleshooting

CAUTION!
► Ensure that the appliance has been discon-
nected from the power in order to prevent
it from being accidentally switched on and
causing injuries.
Cause
A staple or nail is blocking the appliance.
│ GB │ IE
■ 16
to the position "I" to
to the position "0" to
of the appliance onto
.
in the direction of the
along the scale
onto the edge of the
Solution
♦ Open the magazine slider
the tension. Use the hex key (fig. D) to remove
the screws from the face plate
♦ Remove the staple or nail.

Maintenance and cleaning

WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance.
The electric staple gun is maintenance free.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Always clean the appliance directly after
finishing work.
■ Never permit liquids to enter inside the appliance.
■ Use a cloth to clean the housing. Never use
petrol, solvents or cleansers which can damage
plastic.

Disposal

The packaging consists of
environmentally friendly material. It
until it
can be disposed of in the local
recycling containers.
Do not dispose of power tools in
your normal domestic waste!
European Directive 2012/19/EU
requires that worn-out power tools be
collected separately and recycled in an environ-
mentally compatible manner.
Your local community or municipal authorities
can provide information on how to dispose of the
appliance.
Dispose of the packaging in an
environmentally friendly manner.
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary. The packag-
ing material is labelled with abbreviations (a) and
numbers (b) with the following meanings:
1–7: Plastics, 20–22: Paper and cardboard,
80–98: Composites.
. This will remove
.
PET 25 C3