Sony HDW-700A Operation Manual page 29

6 ZEBRA (zebra pattern) switch
This switch controls the zebra pattern on the viewfinder screen.
ON: The zebra pattern is displayed and stays.
OFF: No zebra pattern is displayed.
MOMENT: The zebra pattern is displayed and stays for 5 to 6 seconds.
The zebra pattern is factory set to indicate picture areas where the
video level is approximately 70%. The setup menu can be used to
specify that areas where the video level is 100% and above are to be
displayed at the same time.
For information about how to set the zebra pattern is to be displayed to
indicate areas of 100% or more, see Section 4-7-6 "Setting the Viewfinder"
(page 4-47).
7 TALLY switch
This switch controls the TALLY indicator (1 on page 2-36), setting its
brightness (HIGH or LOW) or turning it off.
HIGH: The TALLY indicator gets brighter.
OFF: The TALLY indicator does not operate.
LOW: The TALLY indicator gets dimmer.
8 Diopter adjustment ring
Use this ring to adjust the viewfinder image for your vision.
Chapter 2 Locations and Functions of Parts and Controls
2
2-15