Table of Contents
Advertisement
Checking the Blade-Brake
Clutch
Check the blade-control bar before each use to ensure
that the blade-brake clutch is operating properly.
Checking with the Grass Bag
1.
Install the empty grass bag on the machine.
2.
Start the engine.
3.
Engage the blade.
Note:
The bag should begin to inflate, indicating
that the blade is engaged and rotating.
4.
Release the blade-control bar.
Note:
If the bag does not immediately deflate,
the blade is still rotating. The blade-brake clutch
may be deteriorating and, if ignored, could
result in an unsafe operating condition. Have
the machine inspected and serviced by an
Authorized Service Dealer.
5.
Shut off the engine and wait for all moving parts
to stop.
Checking without the Grass Bag
1.
Move the machine onto a paved surface in a
non-windy area.
Recycling the Clippings
This machine comes from the factory ready to recycle grass and leaf clippings back into the lawn. To prepare
the machine to recycle:
•
If the grass bag is on the machine, remove it (A of
•
If the rear-discharge plug is not installed, grip it by the handle, raise the rear deflector, and insert it into the
rear-discharge chute until the latch locks into place (B of
2.
Set all 4 wheels to the 76 mm (3 inch)
cutting-height setting; refer to
Cutting Height (page
3.
Take a half sheet of newspaper and crumple it
into a ball small enough to go under the machine
housing (about 76 mm or 3 inches in diameter).
4.
Place the newspaper ball about 13 cm (5 inches)
in front of the machine.
5.
Start the engine.
6.
Engage the blade.
7.
Release the blade-control bar.
8.
Immediately push the machine over the
newspaper ball.
9.
Shut off the engine and wait for all moving parts
to stop.
10.
Go to the front of the machine and check the
newspaper ball.
Note:
If the newspaper ball did not go under
the machine, repeat steps
Note:
If the newspaper is unravelled or
shredded, the blade did not stop properly, which
could result in an unsafe operating condition.
Contact an Authorized Service Dealer.
Figure
19).
Figure
19).
Figure 19
18
Adjusting the
15).
4
through 10.
g236734
Advertisement
Table of Contents
