Checking The Blade-Brake Clutch; Recycling The Clippings - Toro 22285 Operator's Manual

53cm heavy-duty recycler/rear bagger lawn mower
Hide thumbs Also See for 22285:
Table of Contents

Advertisement

Checking the Blade-Brake Clutch

Check the blade-control bar before each use to ensure that the blade-brake clutch is operating properly.
Checking with the Grass Bag
1.
Install the empty grass bag on the machine.
2.
Start the engine.
3.
Engage the blade.
Note:
The bag should begin to inflate, indicating that the blade is engaged and rotating.
4.
Release the blade-control bar.
Note:
If the bag does not immediately deflate, the blade is still rotating. The blade-brake clutch may be
deteriorating and, if ignored, could result in an unsafe operating condition. Have the machine inspected
and serviced by an Authorized Service Dealer.
5.
Shut off the engine and wait for all moving parts to stop.
Checking without the Grass Bag
1.
Move the machine onto a paved surface in a non-windy area.
2.
Set all 4 wheels to the 76 mm (3 inch) cutting-height setting; refer to
3.
Take a half sheet of newspaper and crumple it into a ball small enough to go under the machine housing
(about 76 mm or 3 inches in diameter).
4.
Place the newspaper ball about 13 cm (5 inches) in front of the machine.
5.
Start the engine.
6.
Engage the blade.
7.
Release the blade-control bar.
8.
Immediately push the machine over the newspaper ball.
9.
Shut off the engine and wait for all moving parts to stop.
10.
Go to the front of the machine and check the newspaper ball.
Note:
If the newspaper ball did not go under the machine, repeat steps
Note:
If the newspaper is unravelled or shredded, the blade did not stop properly, which could result in an
unsafe operating condition. Contact an Authorized Service Dealer.

Recycling the Clippings

This machine comes from the factory ready to recycle grass and leaf clippings back into the lawn. To prepare
the machine to recycle:
If the grass bag is on the machine, remove it (A of
If the rear-discharge plug is not installed, grip it by the handle, raise the rear deflector, and insert it into the
rear-discharge chute until the latch locks into place (B of
Adjusting the Cutting Height (page
Figure
20).
Figure
20).
17
4
through 10.
14).

Advertisement

Table of Contents
loading

Table of Contents